of the pocket

 
Author Message
Da answil





Posted: Sun May 18, 2008 00:09    

#12007-03-2995:55: 29
alexa





Especially in the interseason the pocket frequently of , i.e., with the achievement of the preset temperature of heat carrier does extinguish newspaper burner, in three minutes again it is ignited down the pair of seconds, then again in three minutes and so forth it is possible to increase the period of ?
It can change over microswitch on the board SW3/3?
written before the instructions “gives or not delay of 3 minutes after pocket was disconnected on the achievement of the preset temperature” standardly based on the plant the delay of 3 minutes it was included on.
If the delay of 3 minutes is switched off, which does occur with the pocket, when it is included after turning off on the achievement of the preset temperature?
of alexa (2007-65-2717:37: 19)
Back to top
 
Dennec





Posted: Sun May 18, 2008 19:20    

with this system the power down the heating must be mandatorily decreased to the minimum. You will be turned beside our service service, children will help
Back to top
 
DaddyCoal





Posted: Wed May 21, 2008 02:59    

1. System: 7 pig iron batteries, tube 40, . small tank built-in the pocket Nike is mini flue. It godlessly with the programmer and without on 3 minutes (I thus he comprehended, value it is changed, but only down the side of decrease), flame it burns seconds 20 down the heating. One time there was already error 01 - there is no triggering - restart - . I will tomorrow study by heart instructions, but it would be desirable to learn reason.
2. what modulation is considered correct?
Back to top
 
sondymon





Posted: Thu May 22, 2008 01:15    

2 DaddyCool:
What temperature of supply before the heating system was placed?
Back to top
 
DaddyCoal





Posted: Fri May 23, 2008 14:01    

60 degrees, displayed . The duct of the heating old, washing they did not make, capacity is more than 200 liters with the heated area of 60 square meters. With the work with the external sensor it not constantly (apparently, when sensor it forbids work), flame after triggering is returned on minutes power, with the achievement of 65 degrees the flame extinguishes. I so understand on 3 minutes, besides modulation here and he does not smell. And I suspect, that the inspection of the gas flow and the exposure of power minutes- swing also they did not make (I on the work it was). Temperature GVS does also jump perhaps necessary to include the regime of relative? Although this adjustment for the setup man
Back to top
 
sondymon





Posted: Sat May 24, 2008 07:41    

Well why it does not smell… Of the simply minimum power of pocket before 9 kilowatts down your 60 2 on top of that and in the interseason it is too much. The desired power of pocket before this period of year is surely not more than 5 kilowatts, but this is possible only before .
You will look against the work of pocket when it will outboard be considerably lower than zero, with modulation I think all will be before the order.
One more, place supply temperature to 70.
Questions:
1) beyond what temperature they did display room thermostat?
2) in what time pocket does overtake temperature from the cold system to 65 ? if it is rapid that there can be weak circulation, i.e., check the filters of heating system and velocity displayed on the pump
Back to top
 
DaddyCoal





Posted: Mon May 26, 2008 09:21    

1. 20 and 23 degrees
2. time it did not measure, but before the start of flame pocket shows 48, it is not included earlier, apparently, because of the timer or the thermostat. Is turned off flame somewhere through half a minute. The velocity of pump I personally did not touch, but they recommend third. Before the instructions it is not indicated, where is located “electrical three-position speed governor”. I suspect, that on the pump itself. In the evening I will look. of pump is also inaudible . Button, cap - what precisely? They would can in detail, also, with the figure. Although this is the section of erector, hardly all erectors this know and make, not Germany.
Filters are delivered common with the branch sideways. Pocket does work only two weeks, really they could be clogged? Although without the washing of its lines he knows that there before the tubes and as these filters to clean. Also vital topic. Washing, beside .. “special means”, so not .
Back to top
 
sondymon





Posted: Tue May 27, 2008 19:42    

In the cases if pocket is placed on the old heating system we we always recommend to establish fine filters with the grid 100 micrometers these filters they have a crane of washing. After bringing into service it is necessary filter to clean regularly, since “mud” before the old system complete it is full.
If pocket gathers temperature from 48 to 65 above half a minute against the minimum power there is confusion. Weak circulation before the system (, in addition see filters)
If pump they did not change over down 1,2, velocities themselves that it based on the plant stands on 3- Y, for this reason checking there is no meaning to hide pocket and to lose guarantee.
Common coarse filters to clean easily if they are established in the horizontal sector, for this it is necessary to overlap the cranes before and after of filter to unscrew the cover of filter and to merge water with the sludge and to also clean mesh itself.
Back to top
 
braximus





Posted: Wed May 28, 2008 23:28    

, you that I am connected down your discussion… in me similar theme…
Weeks two ago, my pocket (Supermicra 24 S) began also to time, I called the specialist of service center… they as a result said to me that it flew the board of firing, they varied on the guarantee… but they said that it malfunctioned most likely from the long overstresses (for it the upper limit of 240), not beyond the fact that stress in me stands (before the correspondence to guarantee ) necessary to think about the stabilizer….To in the city in the multi-apartment house in the new apartment, constantly to follow thus measured several times yes and problems with the overstress thus far it …
I have two questions
1. why by making so expensive a device “contemporary pocket” it cannot be thought and perfected the module of feed of electronics of pocket (indeed the problem of the stability of stress and correspondence to norms for our country not new, and think not soon she it will be decided, in the city this still normally and for the terrain) and indeed pocket it passed state certification… if no it advise people of Che another!!!
2. if this problem not new, but I on the stories know that very often changes similar boards and other electronics, let the firm struggle (it is judged) as justifying to compensate losses at the point of the service servicing of pockets!!!! Why the common consumer of to answer at the point of voltage regulation before the net???
I will glad read your thoughts gentlemen!!!!
Back to top
 






Posted: Fri May 30, 2008 14:28    

1. why not to do the vehicle, beside which can be poured both the gasoline and kerosene, to solar oil and sunflower oil? only because in “rural terrain” gasoline is not good-quality. and it is not important that all vehicles of this series will become substantially more expensively. even, where there is good-quality gasoline.
2. there is a state standard down the power supply. the elements of electrical units based on this are projected. it would be amusingly observe, as let us assume the representatives of take the samples of gasoline during all servicing and begin for the sake of to be judged….
it seems that before the situations with the problematic power supply there are sufficiently not expensive methods of decision. what problems?
Back to top
 
braximus





Posted: Fri May 30, 2008 15:39    

wrote:
1. why not to do the vehicle, beside which can be poured both the gasoline and kerosene, to solar oil and sunflower oil? only because in “rural terrain” gasoline is not good-quality. and it is not important that all vehicles of this series will become substantially more expensively. even, where there is good-quality gasoline.
2. there is a state standard down the power supply. the elements of electrical units based on this are projected. it would be amusingly observe, as let us assume the representatives of take the samples of gasoline during all servicing and begin for the sake of to be judged….
it seems that before the situations with the problematic power supply there are sufficiently not expensive methods of decision. what problems?
You , but you write completely about the different things… I if already about the gasoline that of you always have a selection among several servicing stations, furthermore at the point of each him it is sold to vapor of brands and furthermore you themselves decide to pour it or not!!!! … I to you not additional filters or accumulators, otherwise they generally and nowhere!!!
P.S The arguments of that who sews bast sandals!!!!
Back to top
 






Posted: Mon Jun 02, 2008 01:48    

before than problem? you will replace the place of residence. there is no selection?
why to me to overpay at the point of “” pocket when problem does exist in you? the price of a question of 20$, and controversy they inflated down the floor- pages.
Back to top
 
braximus





Posted: Tue Jun 03, 2008 23:18    

wrote:
before than problem? you will replace the place of residence. there is no selection?
why to me to overpay at the point of “” pocket when problem does exist in you? the price of a question of 20$, and controversy they inflated down the floor- pages.
Ok, will allow yourselves one additional quotation… interestingly that you you propose at the point of 20$, when normal and less reliable stabilizer stands considerably more expensively… generally in the unit case and for me these are not a question, but problem not only in me! But you became accustomed everyone simple to praise your swamp…
Back to top
 






Posted: Fri Jun 06, 2008 09:42    

give about the swamp
and in me house the pressure of water is weak! since it does not correspond to requirements, I propose beside the pocket to integrate booster pump. only pockets more expensively will become down 100$. and so flue is roughly done. it is necessary beside the pocket to put forced branch. and still that gas besides the tube itself sucked out. if we only- what… man by materials for manufacturing the individual grounding…
if you read this text, then you put to use. and it is not necessary to be , that to join these two references:
http://pawelcom.oo/brodusts/dco/
http://goajle.lo/
Back to top
 
Dennec





Posted: Sun Jun 08, 2008 14:11    

the test of )
Back to top
 
sondymon





Posted: Mon Jun 09, 2008 11:43    

As always they began at the point of and they finished…
When that before the childhood it would shove fork from the radio beside the electro-rosette, it is necessary to be judged with the radio network because of the burnt radio, they could already shove there stabilizer and at the same time and Fermium- receiver and the automatic switch of the regimes of /220…
Back to top
 
Datarin





Posted: Tue Jun 10, 2008 18:13    

sandyman wrote:
As always they began at the point of and they finished…
When that before the childhood it would shove fork from the radio beside the electro-rosette, it is necessary to be judged with the radio network because of the burnt radio, they could already shove there stabilizer and at the same time and Fermium- receiver and the automatic switch of the regimes of /220…
… At the point of everything there are its reasonable requirements, which must be observed!!! This is how based on the childhood shoved so, until now, you shove to people …
… A generally can fit to of pedal and gasoline not to pour…
….Or give advise to each buyer to do his hole, to place autonomous power plant and to connect the ideally purified with the necessary pressure gas (but reduction gear let us throw out)…
Back to top
 






Posted: Fri Jun 13, 2008 02:43    

Tatarin wrote:
… At the point of everything there are its reasonable requirements, which must be observed!!!
specifically, thus. there are not abstract, but completely real norms of electro-gas- water supply. there are norms of deviation. also completely real. before the percentages.
let us touch the electric power supply: you here pocket. type, it was necessary to consider real state of affairs. and what position? it associated with . so they the tampering of electric power by piles remove with the raids. “harmless itself” is this rise down the street line. and that? adjacent units do not know about this? and you personally do not know about this? but you do keep silent for some reason… but if during as neighbor it does warm by stolened in you personally pocket it does not work because of the sag of stress, then themselves you do keep silent, but must arrive some Kiev company and ensure you for the sake of electric power?
furthermore there is a norm of 220 volts + -10%. you speak necessary range wider. and down how much wider? + -20? + -30? well they did this pocket. moreover is more expensive than “the base”, and in you deviation of 40%. again poor pocket! so it can be infinitely. the same situation with gas and water. you do wish to say that there are the pockets, which work with any conditions? name.
you do buy dry grain? no? electric power is the same commodity as grain. why you will not present at the point of claim to seller about the quality? it is inconvenient and it is hopeless? then obediently moisten that “grain”, which does not have alternatives.
howled, when send pockets with the action relays. down the bell, type, stress poor, they answered: again this e…. Herman they did buy? and nothing. at least there where was actually badly something was replaced - on the basis of the city. tenants found explanatory electricians and balanced the load of high-rises. some money on the substation hammered out additional. simply people implemented their work, which did not make many years.
before the majority of the cases there are no problems. there is an unwillingness.
Of (2407-10-0569:59: 13)
Back to top
 



Powered by phpBB © 2001- 2008 phpBB Group